The purpose of the present study is to evaluate the fracture load of composite-based repairs to fractured zirconium oxide (Z) crowns and to ceramic-fused-to-metal (CM) crowns, comparing different mechanical surface preparation methods. A total of 75 crowns were repaired; samples then underwent dynamic loading and thermocycling. Final fracture load values for failure of the repaired crowns were measured and the type of fracture registered. Group I: CM: Surface preparation with a diamond bur + 9.5% Hydrofluoric Acid (HF) etching; Group II): CM: air-particle (Al 2 O 3 ) + 9.5% HF; Group III: CM: Silica coating (SiO 2 ); Group IV): Z: air-particle (Al 2 O 3 ) + HF 9.5%; Group V) Z: Silica coating (SiO 2 ). Of the three CM groups, Group I (CM-diamond bur) showed the highest mean failure value, with significant difference in comparison with Group III (CM-silica coating). For the zirconia groups, the highest value was obtained by Group V (silica coating).
Agustín Panadero, Rubén ; Mateos Palacios, Rocío ; Román Rodríguez, Juan Luis ; Solá Ruiz, María Fernanda ; Fons Font, Antonio. Influence of surface preparation on fracture load of resin composite-based repairs. En: Journal of Clinical and Experimental Dentistry, 2015, Vol. 7, No. 1: 80-83
