Effect of rinsing time and surface contamination on the bond strength of silorane-based and dimethacrylate-based composites to enamel
NAGIOS: RODERIC FUNCIONANDO

Effect of rinsing time and surface contamination on the bond strength of silorane-based and dimethacrylate-based composites to enamel

DSpace Repository

Effect of rinsing time and surface contamination on the bond strength of silorane-based and dimethacrylate-based composites to enamel

Show simple item record

dc.contributor.author Fallahzadeh, Farnoosh es
dc.contributor.author Atai, Mohammad es
dc.contributor.author Ghasemi, Shirin es
dc.contributor.author Mahdkhah, Ailin es
dc.date.accessioned 2019-03-07T11:03:26Z
dc.date.available 2019-03-07T11:03:26Z
dc.date.issued 2018 es
dc.identifier.uri http://hdl.handle.net/10550/69409
dc.description.abstract The aim of this study was to assess whether saliva contamination and rinsing time for 15, 30, and 60 seconds, affects the shear bond strength of silorane and methacrylate-based composites to enamel. Two light cure resin, P60 (3M ESPE) and Filtek LS Silorane were tested. 120 sound premolars were randomly divided into four groups of 30 teeth based on composite type with or without saliva contamination after etching and rinsing. Each group was further divided into three subgroups according to their rinsing time. Then a cylinder of the composite was bonded to the enamel and Shear bond strength was assessed. To determine the failure mode, the bonded surfaces were then observed under SEM. In addition, the DC of each group was measured at pH levels of 4 and 7 using FTIR spectroscopy. The data were analyzed with one-way ANOVA and post hoc analysis followed by Fisher?s least significant difference. The bond strength of the non-contaminated methacrylate group was significantly higher than the other groups (p< 0.0001). In addition, there was no significant deference between the methacrylate subgroups. In the silorane groups, the shear bond strength was higher in the rinsing time of 15 seconds. Failure pattern was mainly adhesive. The DC of the Methacrylates had no significant difference at pH 4 and pH 7, but was significantly higher than that of siloranes (p< 0.0001). While the DC of the siloranes at pH 4 was significantly higher than at pH 7 (p< 0.0001). Saliva contamination in both composites reduces bond strength. Increasing rinsing time in Methacrylates proves ineffective. In non-contaminated siloranes, excessive rinsing time reduced bond strength. The best-recommended rinsing time for both composite is 15 seconds. es
dc.source Fallahzadeh, Farnoosh ; Atai, Mohammad ; Ghasemi, Shirin ; Mahdkhah, Ailin. Effect of rinsing time and surface contamination on the bond strength of silorane-based and dimethacrylate-based composites to enamel. En: Journal of Clinical and Experimental Dentistry, 10 11 2018: 1115-1122 es
dc.title Effect of rinsing time and surface contamination on the bond strength of silorane-based and dimethacrylate-based composites to enamel es
dc.type info:eu-repo/semantics/article en
dc.type info:eu-repo/semantics/publishedVersion en
dc.subject.unesco UNESCO::CIENCIAS MÉDICAS es
dc.identifier.doi 10.4317/jced.55148 es

View       (1.511Mb)

This item appears in the following Collection(s)

Show simple item record

Search DSpace

Advanced Search

Browse

Statistics